Volkswagen Golf Quiz
General body repairs, interior

Removing and installing D-pillar trim

In this manual: General body repairs, interior
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read
Note Removal and installation are described for the left vehicle side. Follow same instructions for the right side as appropriate.

Special tools and workshop equipment required

Removal lever -80 - 200
Removal lever -80 - 200

Removing

  • Remove roof end strip → Chapter.
  • Release D-pillar trim -1- in area of retaining clips -2- from body mountings using removal lever -80 - 200-.
  • Release D-pillar trim -1- from luggage compartment side trim.
  • Unclip D-pillar trim from retaining clips -3-.
  • Pull D-pillar trim -1- downwards out of moulded headliner -arrow-, and remove it.

Installing

Note
  • Before installing, check all fasteners for damage and renew if necessary.
  • Remove any retaining clips -2- left in body mountings using removal tool -T40280- and fit them in D-pillar trim for installation.
  • Following installation, ensure that the D-pillar trim is positioned in rear lid seal beading.

Installation is carried out in reverse order.

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.