Volkswagen Golf Quiz
Heating, air conditioning

Removing and installing fresh air intake, RHD vehicles

In this manual: Heating, air conditioning
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read
0102030405032N·mlb·ft
Tightening torque found on this page

Removing

  • Remove plenum chamber cover → General body repairs, exterior; Rep. gr.50.
  • Remove cover for fresh air intake → Chapter.
  • Remove air quality sensor -G238- (only on vehicles with Climatronic) → Chapter.
  • Remove nuts -arrows-.
  • Remove fresh air intake -1- from plenum chamber.

Installing

Install in reverse order.

Assembly sequence:

  • Align air intake grille on metal collar.
  • Hold air intake grille and screw on outer nut half-way onto welded stud.
  • Screw on nut on opposite side.
  • Tighten outer nut.
  • Tighten centre nut.
Note

The seal -2- must be properly seated on air intake grille.

Water may enter the fresh air intake if the grille is damaged or not properly fitted. This may result in complaints about odours from the heater and air conditioning system and/or about moisture in the vehicle.

Specified torques:
Removing and installing fresh air intake, RHD vehicles
Component Specified torque
Nut 3 N·m

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.