Volkswagen Golf Quiz
Electrical system

Removing and installing steering column switch module, Valeo

In this manual: Electrical system
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read

Removing

  • Move steering wheel to rearmost and lowest position. Use the entire range of adjustment of the steering column for this purpose.
  • Remove steering wheel → Running gear, axles, steering; Rep. gr.48.
  • Remove lower steering column trim → General body repairs, interior; Rep. gr.68.
WARNING

Risk of damage to the electronic components due to electrostatic discharge.

Before disconnecting the electrical connector, the mechanics must electrostatically discharge themselves by briefly grasping hold of door striker plate or similar.
Removing and installing steering column switch module, Valeo
  • Pull out connector lock in direction of arrow -A- and press it down.
  • Disconnect electrical connector -1-.
  • Pull out connector lock in direction of arrow -B- and press it down.
  • Disconnect electrical connector -2-.
  • Press connector lock in direction of arrow -C- and disconnect electrical connector -3-.

Removing and installing steering column switch module, Valeo
  • Press release button -1- on each side in direction of arrow -A-.
  • Pull off steering column switch module -2- slightly.
  • Release retaining tab -3- in direction of arrow -B-.
  • Pull off steering column switch module -2-.

Installing

Install in the reverse order of removal, observing the following:
  • Before pushing on steering column switch module, ensure the following for steering column electronics control unit -J527--3-:

The “arrows”-1- must align.

Coil connector -2- must be visible through window between “arrows”-4-.

Specified torques

→ Chapter „Assembly overview - steering column switch module“
Removing and installing steering column switch module, Valeo

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.