Volkswagen Golf Quiz
Electrical system

Removing and installing turn signal switch -E2-, Valeo

In this manual: Electrical system
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read
Note The turn signal switch -E2-, cruise control system switch -E45- and intermittent wiper switch -E22- are combined to form the steering column combination switch -E595-.

These switches cannot be separated.

If one of the switches is defective, the steering column combination switch -E595- must be renewed as a complete unit.

Removing

  • Remove steering column electronics control unit -J527- → Chapter.
Removing and installing turn signal switch -E2-, Valeo
  • Press release button -1- on each side in direction of arrow -A-.
  • Pull off steering column combination switch -E595--2- slightly.
  • Release retaining tab -3- in direction of arrow -B-.
  • Pull off steering column combination switch -E595--2-.

Installing

Installation is carried out in the reverse sequence.

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.