Electrical system

Removing and installing washer fluid reservoir, »R«

~1min read

Special tools and workshop equipment required

Drip tray

Removing

  • Remove front right wheel → Running gear, axles, steering; Rep. gr.44.
  • Remove front part of right wheel housing liner → General body repairs, exterior; Rep. gr.66.
  • Place drip tray under washer fluid reservoir.
  • Disconnect electrical connector -1-.
  • Release securing clips of water lines -2- and -3-. Pull water lines off washer pump.
  • Release securing clip of water line -3-. Pull water line off headlight washer system pump, and unclip it from washer fluid reservoir.
  • Collect washer fluid in drip tray.
Removing and installing washer fluid reservoir, »R«
  • Remove bolt -1-.
  • Pull upper part of washer fluid reservoir -2- upwards out of seal -3- in lower part of washer fluid reservoir.
Removing and installing washer fluid reservoir, »R«
  • Remove bolts -1-.
  • Slightly lower the lower part of washer fluid reservoir -3-, and release connector -2-.
  • Remove lower part of washer fluid reservoir -3- downwards from vehicle.

Installing

Install in the reverse order of removal, observing the following:

Note The connections at the pump and hoses are colour-marked to prevent incorrect connection of the washer fluid lines to the windscreen and rear window washer pump -V59-. The hose fittings must be connected to the correct colour-coded pump connections during installation.

Specified torques

→ Chapter „Assembly overview – windscreen washer system, with headlight washer system, R“
Removing and installing washer fluid reservoir, »R«

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.