Volkswagen Golf Quiz
Electrical system

Removing and installing washer jets

In this manual: Electrical system
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read

Removing

Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way.
  • Open bonnet.
  • Push spray jet upwards -arrow A- and pull out of flap at the rear -arrow B-.
Removing and installing washer jets
  • Release hose clip -1- in -direction of arrow- and pull hose connection -2- off spray jet -4-.
  • Release and detach connector -3- and remove spray jet -4-.

Installing

Install in the reverse order of removal, observing the following:

Note When connecting the washer fluid line, ensure that the securing clip engages audibly in the connection.
  • Starting at the top, push spray jet into mounting hole until it locks in place audibly.
  • Adjusting spray jets → Chapter
Removing and installing washer jets

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.