Volkswagen Polo Quiz
General Paint Information

One-Part Test Paint

In this manual: General Paint Information
General Paint Information — 128Towing Guide — 10Whels, Tires, Whel Alignment — 126Battery, Starter, Generator, Cruise Control — 65Windshield Wiper/ Washer System — 9Exterior Lights, Switches — 1Interior Lights, Switches — 7Wiring — 51Refrrigerant R134a Servicing — 134
~2min read

Definition:

One-Part Test Paint -LLS MAX 005-, black

Edition 10/2008

Product Description

The One-Part Test Paint -LLS MAX 005- is a single-compound product from the NC resin combinations.

Properties:

Easy application (one-part material)

Dries quickly

High yield

High covering capacity

Even application

Easy to sand

Application Instructions

Application

Detecting uneven surfaces in primer- and filler base surfaces

Base Surface

Suitable base surfaces:

All primers unsanded

All applied fillers unsanded

Pre-treatment of base surfaces:

  • Carefully clean using the Silicone Remover -LLS MAX 007- or Silicone Remover, Long -LLS MAX 0008-.
One-Part Test Paint

Processing

For work safety, wear appropriate, personal protective equipment.

Latex or nitrile protective gloves, for example

Breathing mask, for example type A2/P2

Application:

  • Thoroughly shake the can for at least two minutes and perform a short “spray test”.
One-Part Test Paint

Application type “coat”

  • Apply one misty, thin and even spray application.
  • The recommended dry layer thickness is 15 µm.

Spraying distance:

  • Maintain a distance of 20 to 25 cm.
Note If the spraying procedure is interrupted, make sure that the valve above the spray head is empty to prevent any nozzle blockage.
One-Part Test Paint

Drying

Dry at +20 °C room temperature for 10 minutes. IR drying is possible with this product.
Caution

For work safety, wear appropriate, personal protective equipment.

Note the safety data sheets as well as the warnings on the label of the spray nozzle.

Shake briefly again before every subsequent spray application.

Dispose of the empty spray cans as recyclable material.

Characteristics
One-Part Test Paint
Solid matter content approximately 16 %
Yield Approximately 0.5 m² / spray can with 30 to 40 μm dry layer thickness
Note Used only by a professional
VOC value The EU limit for this product (product category IIB.b) in ready-to-use form is a maximum of 650 to 693 g/L volatile organic compounds. The VOC value of this product in ready-to-use form is a maximum of 260 to 277 g/can.

Storage

The guaranteed shelf life of 60 months from date of manufacture. Use no later than the date indicated on the label and store in original container at +20 °C.
One-Part Test Paint

Test yourself

A quick Volkswagen Polo quiz: every answer comes with an explanation and a link to the manual page.