Self Help

Wheel bolts

~3min read
0408012016020011081N·mlb·ft
Tightening torque found on this page
Fig. 151

Changing a wheel: loosen the wheel bolts.


Fig. 152

Changing a wheel: tire valve ① and
installation position of the anti-theft wheel bolt ②.

Read and observe the introductory information
and safety warnings first
⇒Introduction
to the topic

To loosen the wheel bolts, use only the wheel wrench supplied with the vehicle.

Loosen the wheel bolts by only about one turn while the vehicle is not raised with the jack.

If a wheel bolt cannot be loosened, carefully press down on the end of the wheel wrench with your foot. Hold on to the vehicle and make sure you have a secure footing.

Loosening the wheel bolts
  • Push the wheel wrench onto the wheel bolt as far as it will go ⇒ Fig. 151 .
  • Grip the end of the wheel wrench and turn the wheel bolt counterclockwise by about one turn ⇒ .
Loosening the anti-theft wheel bolt

On a wheel with a wheel trim, the anti-theft wheel bolt must be installed at position ⇒ Fig. 152②. Otherwise the wheel trim cannot be fitted.

  • Remove the adapter for the anti-theft wheel bolt from the onboard tool kit.
  • Push the adapter into the anti-theft wheel bolt as far as it will go ⇒ Fig. 152 .
  • Push the wheel wrench onto the adapter as far as it will go.
  • Grip the end of the wheel wrench and turn the wheel bolt counterclockwise by about one turn ⇒ .
Important information about wheel bolts

Rims and wheel bolts are designed specifically for the wheels fitted at the factory. Whenever you convert to different rims, always use wheel bolts with the correct length and seat shape for those rims. The secure fit of the wheels and the function of the braking system depend on this.

Under certain circumstances, wheel bolts from vehicles of the same model series must not be used.

Tightening torque of the wheel bolts

The specified tightening torque for the wheel bolts on steel and alloy rims is 110 N·m. After changing a wheel, have the tightening torque checked immediately with a properly functioning torque wrench.

Corroded or stiff wheel bolts must be replaced before checking the tightening torque, and the threads in the wheel hub must be cleaned.

Never grease or oil the wheel bolts or the threads in the wheel hubs. Even at the specified tightening torque, the bolts can loosen while driving.

Warning
Improperly tightened wheel bolts can come loose while driving and cause accidents, serious injury, and loss of vehicle control.
  • Only use wheel bolts that belong to the respective rim.
  • Never use mismatched wheel bolts.
  • Wheel bolts and the threads of the wheel hubs must be clean, move freely, and be free of oil and grease.
  • Always use only the wheel wrench supplied with the vehicle from the factory to loosen and tighten the wheel bolts.
  • Loosen the wheel bolts by only about one turn while the vehicle is not raised with the jack.
  • Never grease or oil the wheel bolts or the threads in the wheel hubs. Even at the specified tightening torque, the bolts can loosen while driving.
  • Never loosen the bolts on wheels with a bolted rim ring.
  • If the wheel bolts are tightened with too low a torque, the wheel bolts and rims can loosen while driving. A significantly excessive tightening torque can damage the wheel bolts or the threads.