Vehicle-specific paint information
Underbody protection
In this manual: Vehicle-specific paint information
9steps
~54min
2/5difficulty
Done 0 of 9
Underbody protection protected areas, overall body view with various layer thicknesses
![]()
Note
- During repair, restore the underbody protection (stone chip protection) to match the original appearance and layer thickness.
- Drain holes must remain open.
- All threaded studs and weld nuts with M thread, as well as all other studs and mating surfaces for installation, must be functional after applying the underbody protection.
Underbody protection overall view

- Underbody protection
- Layer thickness 0.3 mm
- Underbody protection
- Layer thickness 0.7 mm
- Underbody protection
- Layer thickness 0.5 mm
Underbody protection protected areas
![]()
Note
- During repair, restore the underbody protection (stone chip protection) to match the original appearance and layer thickness.
- Drain holes must remain open.
- All threaded studs and weld nuts with M thread, as well as all other studs and mating surfaces for installation, must be functional after applying the underbody protection.
Underbody protection spare wheel well
- Upper illustration shows a CNG vehicle (gas vehicle)
- Lower illustration shows a conventional vehicle

- Underbody protection
- Layer thickness 0.5 mm
![]()
Note
- During repair, restore the underbody protection (stone chip protection) to match the original appearance and layer thickness.
- Drain holes must remain open.
- All threaded studs and weld nuts with M thread, as well as all other studs and mating surfaces for installation, must be functional after applying the underbody protection.
Underbody protection front strut mount reinforcement
Left side shown, right side mirrored

- Underbody protection
- Layer thickness 0.3 mm
![]()
Note
- During repair, restore the underbody protection (stone chip protection) to match the original appearance and layer thickness.
- Drain holes must remain open.
- All threaded studs and weld nuts with M thread, as well as all other studs and mating surfaces for installation, must be functional after applying the underbody protection.
Underbody protection sill
Left side shown, right side mirrored

- Underbody protection
- Layer thickness 0.7 mm
- Underbody protection
- Layer thickness 0.5 mm
![]()
Note
- During repair, restore the underbody protection (stone chip protection) to match the original appearance and layer thickness.
- Drain holes must remain open.
- All threaded studs and weld nuts with M thread, as well as all other studs and mating surfaces for installation, must be functional after applying the underbody protection.
Underbody protection sill with sectional view
Left side shown, right side mirrored

- Underbody protection
- Layer thickness 0.7 mm
- Underbody protection
- Layer thickness 0.5 mm
- Side panel outer
- Inner sill
- Dimension x
- UP: 10 mm PVC keep-free area
- Dimension y
- Cross UP 37-45 mm PVC keep-free area
Was this page helpful?