Yamaha YZF-R125 Quiz
Periodic maintenance and adjustment

Checking the spark plug

In this manual: Periodic maintenance and adjustment
Introduction — 1Important manual information — 1Safety information — 9Description — 4Instrument and control functions — 16For your safety - pre-operation checks — 1Operation and important riding points — 6Periodic maintenance and adjustment — 43Motorcycle care and storage — 4Specifications — 1Consumer information — 2
8steps
~48min
2/5difficulty
0102030405012.59N·mlb·ft
Tightening torque found on this page
Done 0 of 8

The spark plug is an important engine component, which is easy to check. Since heat and deposits will cause any spark plug to slowly erode, the spark plug should be removed and checked in accordance with the periodic maintenance and lubrication chart. In addition, the condition of the spark plug can reveal the condition of the engine.

To remove the spark plug
  1. Remove cowling A.
  2. Remove the spark plug cap.

  1. Spark plug cap

  2. 3. Remove the spark plug as shown, with the spark plug wrench included in the owner's tool kit.

  1. Spark plug wrench

To check the spark plug
  1. Check that the porcelain insulator around the center electrode of the spark plug is a medium-to-light tan (the ideal color when the vehicle is ridden normally).
TIP
If the spark plug shows a distinctly different color, the engine could be operating improperly. Do not attempt to diagnose such problems yourself. Instead, have a Yamaha dealer check the vehicle.
  1. Check the spark plug for electrode erosion and excessive carbon or other deposits, and replace it if necessary.

Specified spark plug: NGK/CR8E

To install the spark plug
  1. Measure the spark plug gap with a wire thickness gauge and, if necessary, adjust the gap to specification.

  1. Spark plug gap

Spark plug gap: 0.7-0.8 mm (0.028-0.031 in)

  1. Clean the surface of the spark plug gasket and its mating surface, and then wipe off any grime from the spark plug threads.
  2. Install the spark plug with the spark plug wrench, and then tighten it to the specified torque.

Tightening torque: Spark plug: 12,5 N·m

TIP
If a torque wrench is not available when installing a spark plug, a good estimate of the correct torque is 1/4-1/2 turn past finger tight. However, the spark plug should be tightened to the specified torque as soon as possible.
  1. Install the spark plug cap.
  2. Install the cowling.

Test yourself

A quick Yamaha YZF-R125 quiz: every answer comes with an explanation and a link to the manual page.