Body

Instrument Panel Vent, Removing and Installing

~3min read

Driver Side Instrument Panel Vent, Removing and Installing

Special tools and workshop equipment required

  • Hook Tool -T40207-

Removing

- Remove the instrument cluster gap cover. Refer to → Chapter "Instrument Cluster Gap Cover, Removing and Installing".

- Removing the trim for the instrument panel. Refer to → Chapter "Instrument Panel Decorative Trim, Removing and Installing, Driver Side".

- Remove the instrument panel vent cover. Refer to → Chapter "Instrument Panel Rear Cover, Removing and Installing".

- Remove the Light Switch -E1-. Refer to → Electrical Equipment; Rep. Gr.96; Controls; Overview - Instrument Panel Controls.

- Remove the bolt -2-.

Note

The vent has a hole on both sides for attaching the Hook Tool -T40207-.

- Carefully insert the Hook Tool -T40207- between the slats and hook it into the side of the vent.

- Remove the vents -1- on both sides alternating from side to side -arrows-.

- Reach through the opening for the light switch, disconnect the connector and remove the instrument panel vent.

Installing

Install in reverse order of removal. Note the following:

Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Instrument Panel".

A70-11537

Passenger Side Instrument Panel Vent, Removing and Installing

Special tools and workshop equipment required

  • Hook Tool -T40207-

Removing

Note

The vent has a hole on both sides for attaching the Hook Tool -T40207-.

- Carefully insert the Hook Tool -T40207- between the slats and hook it into the side of the vent.

- Alternating between the sides, carefully remove the vent -1- from the installation opening -arrow-.

- Disconnect the connector.

Installing

Install in reverse order of removal. Note the following:

Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Instrument Panel".

A70-11677

Center Instrument Panel Vent, Removing and Installing

Special tools and workshop equipment required

  • Wedge Set -T10383-

Removing

- Remove the instrument cluster gap cover. Refer to → Chapter "Instrument Cluster Gap Cover, Removing and Installing".

- Remove the display unit cover. Refer to → Chapter "Instrument Panel Rear Cover, Removing and Installing".

- Remove the bolts -1 and 3-.

- Pry the instrument panel vent -2- out of the instrument panel toward the rear using the Wedge Set -T10383/1--arrows-.

- Disconnect the connectors and remove the instrument panel vent.

Installing

Install in reverse order of removal. Note the following:

Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Instrument Panel".

A70-11539

Front Center Defroster Vent, Removing and Installing

Special tools and workshop equipment required

  • Wedge Set -T10383-

Removing

- Remove the center speaker trim. Refer to → Chapter "Center Speaker Trim, Removing and Installing".

- Remove the bolts -2-.

- Pry the defroster vent -1- out of the instrument panel -arrow- at the rear using the Wedge Set -T10383/1- and remove it toward the rear.

Installing

Install in reverse order of removal. Note the following:

Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Instrument Panel".

A70-11541

Side Defroster Vent, Removing and Installing

Special tools and workshop equipment required

  • Trim Removal Wedge -3409-

Removing

- Remove the defroster vent -1- from the instrument panel -arrow- using a Trim Removal Wedge -3409-.

Installing

Install in reverse order of removal. Note the following:

Installation notes, for example tightening specifications, replacing components. Refer to → Chapter "Overview - Instrument Panel".

A70-11540