Electrical System

Rear Lid Opener Control Module -J938-, Removing and Installing

~2min read

WARNING

Risk of leg injury.

Stay outside of the swivel range of the trailer hitch when releasing the trailer hitch.

Removing

- Extend the trailer hitch ball head. Refer to Owner's Manual.

- Remove the bolts -arrows- on the bottom side of the bumper cover.

A63-10729

- Disconnect the connectors -1 and 2-.

- Remove the screw -4-.

- Remove the control module -3- from the brackets on the bumper cover -arrows-.

A96-11013

- If the control module is being replaced, release the clip -3--arrow- and disengage the bracket -2- on the control module -1-,

Installing

Install in reverse order of removal.

Tightening Specifications

  • Rear bumper. Refer to → Body Exterior; Rep. Gr.63; Rear Bumper; Overview - Bumper Cover.
A96-11014

Power Rear Lid Opener Sensor -G750-/Rear Lid Opener Sensor 2 -G760-, Removing and Installing

Power Rear Lid Opener Sensor -G750-/Rear Lid Opener Sensor 2 -G760-, Removing and Installing, without Trailer Hitch

Removing

- Remove the bolts -arrows- on the bottom side of the bumper cover.

- Remove the mount -1- with the sensor.

A63-10729

- Disconnect the connector -1-.

- Cut through the cable tie -2-.

- Remove the sensors -3 and 4- from the tabs -arrows-.

Installing

Install in reverse order of removal. Note the following:

- The Rear Lid Opener Sensor 2 -G760- must be mounted at the top of the bumper cover.

  • How to recognize: Pin "4 and 5" at the connector.

Tightening Specifications

  • Rear bumper. Refer to → Body Exterior; Rep. Gr.63; Rear Bumper; Overview - Bumper Cover.
A96-11015

Power Rear Lid Opener Sensor -G750-/Rear Lid Opener Sensor 2 -G760-, Removing and Installing, with Trailer Hitch

Removing

- Remove the bolts -arrows- on the bottom side of the bumper cover.

- Remove the mount -1- with the sensor.

A63-11014

- Disconnect the connector -1-.

- Remove the sensors -2- from the tabs -arrows-.

Installing

Install in reverse order of removal. Note the following:

- The Rear Lid Opener Sensor 2 -G760- must be mounted at the top of the bumper cover.

  • How to recognize: Pin "4 and 5" at the connector.

Tightening Specifications

  • Rear bumper. Refer to → Body Exterior; Rep. Gr.63; Rear Bumper; Overview - Bumper Cover.
A94-11738