Body

Spoiler, Removing and Installing

~3min read
0102030405043N·mlb·ft
Tightening torque found on this page

Rear Lid Spoiler, Removing and Installing

Special tools and workshop equipment required

  • Trim Removal Wedge -3409-
  • Wiring Harness Repair Set - Hot Air Blower -VAS1978/14A-
  • Cleaning Solution -D 009 401 04-
  • Bonded Window Tool Kit -VAG1351-

Spoiler, Removing

- Tape off the rear lid in the cutting section with adhesive tape -4-.

- Insert the Cutting Tool for Bonded Windows - Wire -VAS6452/2--2- on one side between the spoiler -1- and the rear lid.

- Insert the ends of the cutting wire in two pull handles from the Bonded Window Tool Kit -VAG1351-.

Cut through the double-sided adhesive tape -3- on the spoiler starting from one side going to the opposite.

- Before reinstallation, completely remove any adhesive residue from the rear lid and spoiler.

- During installation, position the spoiler toward the rear up to the imaginary line -item 5- and centered to the rear lid.

Installing

Note

The rear lid and spoiler must be at room temperature before installing.

- Remove the adhesive residue on the rear lid and the spoiler and clean using the Cleaning Solution -D 009 401 04-.

A66-11742

- Warm the rear lid in the adhesion area using the Hot Air Blower -VAG1416-.

- Mount the spoiler toward the rear up to the imaginary line -5- on the rear lid with the help of a second technician.

- Gradually remove the protective film between the rear lid and the spoiler up to the opposite side while pressing on the spoiler.

- Press on the spoiler strongly from the center going outward.

Rear Lid Spoiler, Removing and Installing

Roof Edge Spoiler, Removing and Installing

Roof Edge Spoiler, Removing and Installing

1 - Spoiler on Roof Edge

  • Removing
  • Remove the rear lid trim

- Remove the nuts -4- and bolts -5-.

- Disconnect the connector from the brake lamp.

- Unclip the clip -2- from the outside one after the other.

  • Installing

- Install in reverse order of removal. Push the clips all the way into the rear lid.

2 - Clip

3 - Rear Lid

4 - Nut

  • 4 N·m

5 - Screw

  • 2,5 N·m

Roof Edge Spoiler Seal, Removing and Installing

Special tools and workshop equipment required

  • Cleaning Solution -D 009 401 04-

Removing

- Remove the spoiler on the edge of the roof. Refer to → Chapter "Roof Edge Spoiler, Removing and Installing".

- Pull the seals -2 and 3- off the spoiler on the edge of the roof.

Installing

Install in reverse order of removal and note the following:

- Remove any remaining adhesive, if necessary.

- The adhesive surfaces must be free of dust and grease.

- Clean the adhesive surface of the spoiler using Cleaning Solution -D 009 401 04-.

- Remove the peel-off backing from the seals.

- Position the seals in the center of the spoiler on the edge of the roof and press them on.

A55-10801