Removal and Installation - Air Deflector

Removal

1. 1
   Move the sunroof glass panel to the fully OPEN position.

   

2. 2
   
   Disconnect the air deflector wire.
   

   1. Press the metal rod to disconnect the rod from the plastic clips.

   2. Pull the air deflector rod outward and slightly upward, and disconnect it from the clips.

   

3. 3
   Gently pull the metal air deflector rod and disconnect both ends of the wire.

   

4. 4
   
   Rotate the front of the air deflector 90 degrees toward the rear and remove the air deflector.
   

   • Disconnect the end cap by rotating the air deflector lever 90 degrees from the pivot point.

   

Installation

1. 1
   Position and install the air deflector on the frame.

   

2. 2
   Make sure the spring is correctly installed inside the guide.

   

3. 3
   Securely fasten all 6 clips with the air deflector rod.

   

4. 4
   Insert the air deflector rod into the hole in the plastic part on both sides.

   

5. 5
   Make sure the spring is located within the sliding area of the end cap.

   

6. 6
   Make sure the Y-shaped gap between the guide and the end cap is approximately 4 mm.

   

7. 7
   Move the sunroof glass to the fully CLOSED position.

   

8. 8
   Initialize the sunroof panel.
   Refer to: Power Sunroof Initialization (501-17 Sunroof Panel, General Procedures).