Ford Fiesta Quiz
Manual Transmission, Clutch, Transfer Case and Power Transfer Unit

Clutch Pedal - Removal and Installation

In this manual: Manual Transmission, Clutch, Transfer Case and Power Transfer Unit
Service Information — 27Suspension — 48Transmission — 9Brake System — 52Steering — 21Engine — 140Manual Transmission, Clutch, Transfer Case and Power Transfer Unit — 48Exhaust System — 6Fuel System — 21Climate Control System — 58Instrumentation and Warning Systems — 26Battery and Charging System — 20Infotainment Systems — 41Lighting — 29Power Distribution — 11Electronic Function Group — 30Body and Paint — 275Frame and Mounting — 3
7steps
~47min
3/5difficulty
1special tools
010203040502518N·mlb·ft
Tightening torque found on this page
Done 0 of 7

Removal

NOTICE: Do not spill brake fluid on painted or plastic surfaces, or surface damage may occur. If brake fluid is spilled on a painted or plastic surface, immediately wash the surface with water.

  1. Remove the battery tray.
    Refer to: Battery Compartment — 1.6 L Duratec-16V Ti-VCT (88 kW/120 L PS) — Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
  2. Using a suction device, drain the brake fluid from the reservoir to the MIN mark.
  3. Disconnect and remove the clutch tube fittings.
    • Release the retainer and disconnect the electrical connector.
    • Remove the nuts and the clutch pedal.

Installation

    • Install the clutch pedal and nuts.
      Torque: 18 lb-ft (25 N·m)
    • Install the retainer and connect the electrical connector.
  2. Install the clutch tube fittings.
  3. Bleed the clutch system.
    Refer to: Clutch System Bleeding (308-02 Clutch Controls - 5-Speed Manual Transmission; Manual Transmission - B5/IB5/6-Speed Manual Transmission - B6, General Procedures).

Test yourself

A quick Ford Fiesta quiz: every answer comes with an explanation and a link to the manual page.