Flywheel - Engine - 2.0L - in Vehicle Repair

Holding Tool, Flywheel 303-103 (T74P-8375-A)

1. 1
   With vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
2. 2
   Remove the manual transaxle and clutch. For additional information, refer to Section 308-01 and Section 308-03.
3. 3
   Install the Flywheel Holding Tool and remove the 6 bolts and the flywheel.

Engine balancing is not required. Balance weights should not be installed on the new flywheel.

Special bolts are used for installation. Do not use standard bolts.

1. 1
   Install the flywheel and the 6 bolts.
2. 2
   Install the Flywheel Holding Tool.

3. NOTE: Special bolts are used for installation. Do not use standard bolts.

   Tighten the bolts in the sequence shown in 3 stages.

   • Stage 1: Tighten to 50 N·m.
   • Stage 2: Tighten to 80 N·m.
   • Stage 3: Tighten to 112 N·m.

4. Install the clutch and manual transaxle. For additional information, refer to Section 308-01 and Section 308-03.