Accessories
Rear Speaker Removal, Installation, and Test (Natural Gas models)
013100 LEFT REAR
0131A8 RIGHT REAR
Removal
- Rear Seat Cushion
 |
|
1. |
Remove the bolt (A) securing the rear seat cushion (B). |
|
 |
|
2. |
While pushing down the rear seat cushion (A), pull the seat hook handles (B) to release the hooks (C). |
|
3. |
Remove the rear seat cushion. |
|
- Rear Seat-Back (Natural Gas Model)
 |
|
1. |
Release the center seat belt (A) from the center belt guide (B). |
|
 |
|
3. |
Remove the rear seat-back (A). |
|
- Both Rear Door Opening Seals as Needed
 |
|
1. |
Remove the rear door opening seal (A) as needed. |
|
2. |
The left side is shown; repeat on the right side. |
|
- Both C-Pillar Trims
 |
|
1. |
Pull out the C-pillar trim (A) to release the clips. |
|
2. |
Remove the C-pillar trim. |
|
NOTE: The front clip (B) will stay in the body. |
|
3. |
The left side is shown; repeat on the right side. |
|
 |
|
4. |
Remove the front clip (A). |
|
5. |
The left side is shown; repeat on the right side. |
|
- Rear Shelf (Natural Gas Model)
 |
|
1. |
From the trunk compartment, disconnect the connector (A). |
|
 |
|
2. |
From the trunk compartment, detach the clips (A). |
|
|
3. |
Pull out both rear seat belts (A) and the rear center seat belt (B) through the slits in the rear shelf trim (C), then remove the rear shelf trim. |
- Rear Speaker
 |
|
1. |
Remove the screw. Remove the rear speaker (A) by tilting it forward to release the clips (B). |
|
2. |
Disconnect the connector. |
|
Test
- Rear Speaker - Test
 |
|
1. |
Measure the resistance between terminals No. 1 and No. 2. There should be about 4 ?. |
|
2. |
If the resistance is not as specified, replace the rear speaker (A). |
|
Installation
- Rear Speaker
mmmmwzzm.mwn
|
|
1. |
Connect the connector. |
|
2. |
Install the rear speaker (A). |
|
- Rear Shelf (Natural Gas Model)
|
1. |
Slip the rear seat belts (A) and the rear center seat belt (B) through the slits in the rear shelf trim (C). |
 |
|
2. |
Install the clips (A). |
|
 |
|
3. |
From the trunk compartment, connect the connector (A). |
|
- Both C-Pillar Trims
 |
|
1. |
Install the new front clip (A) to the C-pillar trim (B). |
|
 |
|
2. |
Install the C-pillar trim (A). |
|
NOTE: |
|
 |
Make sure the side curtain airbag is not tucked under the clips or the ribs. |
|
|
 |
Do not push too hard on the C-pillar trim. If you push too hard, the clip will be damaged, and it will not hold the trim properly. |
|
|
 |
Gently tug on the C-pillar trim to verify that all clips are securely fastened. |
|
|
|
3. |
The left side is shown; repeat on the right side. |
|
- Both Rear Door Opening Seals as Needed
 |
|
1. |
Install the rear door opening seal (A). |
|
2. |
The left side is shown; repeat on the right side. |
|
- Rear Seat-Back (Natural Gas Model)
 |
|
1. |
Install the rear seat-back (A). |
|
m.imim
|
|
2. |
Install the bolts (A). |
|
 |
|
3. |
Install the center seat belt (A) to the center belt guide (B). |
|
- Rear Seat Cushion
 |
|
1. |
Install the hooks (A) to the rear seat cushion clips (B). |
|
 |
|
2. |
Install the bolt (A) securing the rear seat cushion (B). |
|
?
Test yourself
A quick Honda Civic quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?