Accessories
Subwoofer Removal, Installation, and Test (4-door)
012140
Removal
NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
- Rear Seat Cushion
 |
|
1. |
Remove the bolt (A) securing the rear seat cushion (B). |
|
 |
|
2. |
While pushing down the rear seat cushion (A), pull the seat hook handles (B) to release the hooks (C). |
|
3. |
Remove the rear seat cushion. |
|
- Both Rear Seat Side Bolsters
 |
|
1. |
Remove the bolt (A) securing the rear seat side bolster (B). |
|
2. |
The left side is shown; repeat on the right side. |
|
 |
|
3. |
Remove the rear seat side bolster (A). |
|
4. |
The left side is shown; repeat on the right side. |
|
- Both Rear Door Opening Seals as Needed
 |
|
1. |
Remove the rear door opening seal (A) as needed. |
|
2. |
The left side is shown; repeat on the right side. |
|
- Both C-Pillar Trims
 |
|
1. |
Pull out the C-pillar trim (A) to release the clips. |
|
2. |
Remove the C-pillar trim. |
|
NOTE: The front clip (B) will stay in the body. |
|
3. |
The left side is shown; repeat on the right side. |
|
 |
|
4. |
Remove the front clip (A). |
|
5. |
The left side is shown; repeat on the right side. |
|
- Rear Shelf Trim
 |
|
1. |
Fold down the seat-back(s). |
|
2. |
From the trunk compartment, disconnect the connector (A). |
|
 |
|
3. |
From the trunk compartment, detach the clips (A). |
|
 |
|
4. |
Release the hooks (A). |
|
 |
|
5. |
Pull out both rear seat belts (A) and the rear center seat belt (B) through the slits in the rear shelf trim (C), then remove the rear shelf trim. |
|
- Subwoofer
 |
|
1. |
Remove the bolts, and remove subwoofer (A). |
|
2. |
Disconnect the subwoofer connecctor. |
|
Test
- Subwoofer - Test
 |
|
1. |
Measure the resistance between terminals No. 1 and No. 2. There should be about 2 ?. |
|
2. |
If the resistance is not as specified, replace the subwoofer (A). |
|
Installation
NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
- Subwoofer
 |
|
1. |
Connect the subwoofer connecctor. |
|
2. |
Install the subwoofer (A). |
|
- Rear Shelf Trim
 |
|
1. |
Slip the rear seat belts (A) and the rear center seat belt (B) through the slits in the rear shelf trim (C). |
|
 |
|
2. |
Install the hooks (A). |
|
 |
|
3. |
Install the clips (A). |
|
 |
|
4. |
From the trunk compartment, connect the connector (A). |
|
5. |
Raise the seat-back(s). |
|
- Both C-Pillar Trims
 |
|
1. |
Install the new front clip (A) to the C-pillar trim (B). |
|
 |
|
2. |
Install the C-pillar trim (A). |
|
NOTE: |
|
 |
Make sure the side curtain airbag is not tucked under the clips or the ribs. |
|
|
 |
Do not push too hard on the C-pillar trim. If you push too hard, the clip will be damaged, and it will not hold the trim properly. |
|
|
 |
Gently tug on the C-pillar trim to verify that all clips are securely fastened. |
|
|
|
3. |
The left side is shown; repeat on the right side. |
|
- Both Rear Door Opening Seals as Needed
 |
|
1. |
Install the rear door opening seal (A). |
|
2. |
The left side is shown; repeat on the right side. |
|
- Both Rear Seat Side Bolsters
 |
|
1. |
Install the rear seat side bolster (A). |
|
2. |
The left side is shown; repeat on the right side. |
|
mmmmlnss
|
|
3. |
Install the bolt (A) securing the rear seat side bolster (B). |
|
4. |
The left side is shown; repeat on the right side. |
|
- Rear Seat Cushion
 |
|
1. |
Install the hooks (A) to the rear seat cushion clips (B). |
|
 |
|
2. |
Install the bolt (A) securing the rear seat cushion (B). |
|
?
Test yourself
A quick Honda Civic quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?