Honda Civic Quiz
Accessories

Tweeter Removal and Installation

In this manual: Accessories
Accessories — 57Body — 310Chassis — 96Electrical — 15HVAC — 39Powertrain — 300Moonroof/Sunroof — 9Roof Drainage — 5Wiper Arm/Nozzle Adjustment — 1ELD Removal and Installation — 1Under-Dash Fuse/Relay Box Removal and Installation (KA KX models without Keyless Access System) — 1Under-Dash Fuse/Relay Box Removal and Installation (KA models with Keyless Access System) — 1
~1min read

014175 LEFT


014185 RIGHT

Removal

NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.


  1. Front Door Opening Seal as Needed

1.

Remove the front door opening seal (A) as needed.

  1. A-Pillar Trim

1.

Pull out the A-pillar trim (A) to release the clips.

2.

Put a shop towel (A) in the opening between the A-pillar trim (B) and the dashboard to prevent dropping the A-pillar clips.

3.

Remove the A-pillar trim (A).

NOTE: The upper clip (B) will stay in the body.

4.

Remove the upper clip (A) from the body.

  1. Tweeter

1.

Remove the tweeter (A).

Installation

NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.


  1. Tweeter

1.

Install the tweeter (A).

  1. A-Pillar Trim

1.

Carefully install the new upper clip (A) to the A-pillar trim (B).

2.

Install the A-pillar trim (A).

NOTE:

Make sure the side curtain airbag is not tucked under the clips or the trim ribs.

Do not push too hard on the A-pillar trim. If you push too hard, the clip will be damaged, and it will not hold the trim properly.

Gently tug on the A-pillar trim to verify that all clips are securely fastened.

  1. Front Door Opening Seal as Needed

1.

Install the front door opening seal (A).

Test yourself

A quick Honda Civic quiz: every answer comes with an explanation and a link to the manual page.