Hyundai Elantra AD Quiz
Body (Interior and Exterior)

Rear Door Lock Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
7steps
~42min
2/5difficulty
Done 0 of 7

Replacement

  1. Remove the rear door module. (Refer to Rear Door - "Rear Door Module")
  2. Remove the rear door inside handle (A).
  3. Disconnect the rear door lock connector (A).
  4. Loosen the mounting bolt and remove the rear door latch (A).
  5. Remove the rear door outside handle base (A) by pressing the stopper pins at the rear.
  6. Remove the rear door outside handle cable (A).
  7. To install, reverse the removal procedure.
    • Make sure the connector is properly connected.
    • Check that the door locks/unlocks and opens/closes properly.
    • Replace any damaged clips (or pin-type retainers).

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.