Repair Procedures

Adjustment

Inspect the glass guide for damage or wear, and replace if necessary.

1. 1
   Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")
2. 2
   Separate the mounting plug hole (A) from the rear door module.

   

3. 3
   After loosening the window mounting bolts, adjust the window gap (A) by moving the window side to side, then tighten the bolts.

   

4. 4
   Check that the window operates normally.

Make sure the door latches securely without slamming it. If necessary to adjust the striker (A): The striker nuts are secured. The striker can be precisely adjusted up or down, in or out.

1. 1
   After loosening the mounting screw, adjust the latch (A) by moving it forward and backward or side to side, then tighten the bolts (B).

   Tightening torque: (B): 18.6 ~ 22 N·m

   

2. 2
   Tap the striker with a plastic hammer to adjust it. The striker will not move much, but will allow some adjustment.
3. 3
   While holding the outside handle, press the door against the body to make sure the striker is flush with the body. If the door latches properly, tighten the bolts and recheck.

After installing the rear door, check that the body is flush/parallel with all edges of the front door. Make sure the door and body edges are parallel. Replace the mounting bolts before adjustment.

1. 1
   Make sure the door and body edges are parallel.

   

2. 2
   When adjusting the doors, place the vehicle on a hard, level surface.
3. 3
   Adjust the hinges (A):

   A.	Slightly loosen the door mounting bolts and move the door inward or outward until it is flush with the body.

   B.	Slightly loosen the hinge mounting bolts and move the door forward or backward, up or down, to align the gaps.

   C.	Place a shop towel on the jack to avoid damaging the door during adjustment.

   Tightening torque: (B): 21.6 ~ 26 N·m (C): 37.3 ~ 41 N·m

   

4. 4
   Apply grease to the hinge moving parts indicated by the arrows.
5. 5
   Check for water leaks.