Power Adjustment

The front seat can be adjusted using the control switches located on the outside of the seat cushion. Before driving, adjust the seat to a proper position so that you can easily operate the steering wheel, pedals, and controls on the instrument panel.

WARNING

NEVER leave children unattended in the vehicle. Power seats operate when the vehicle is off.

NOTICE

To prevent damage to the seats:

• Always stop adjusting the seat when it has moved as far forward or backward as possible.
• Do not operate the seat longer than necessary when the vehicle is off. This may cause unnecessary battery discharge.
• Do not operate two or more seats at the same time. This may cause an electrical malfunction.

Forward and Backward Adjustment

To move the seat forward or backward:

1. Press the control switch forward or backward.

2. Release the switch as soon as the seat reaches the desired position.

Seatback Angle

To adjust the seatback:

1. Turn the upper part of the control switch forward or backward.

2. Release the switch as soon as the seatback reaches the desired position.

Reclining Seatback

Sitting in a reclined position while the vehicle is moving can be dangerous. Even when wearing the seat belt, your safety system (seat belts and airbags) is significantly reduced if the seatback is reclined.

WARNING

NEVER drive with the seatback reclined while the vehicle is moving. Riding with a reclined seatback increases your chance of serious or fatal injury in a collision or sudden stop. Drivers and passengers must ALWAYS sit upright, properly belted, with the seatback in the upright position.

Seat belts must fit snugly against the hips and chest to work properly. When the seatback is reclined, the shoulder belt cannot do its job because it will not fit snugly against the chest. Instead, it will be in front of you. During an accident, you may be thrown into the seat belt, causing neck or other injuries. The more the seatback is reclined, the greater the chance that the occupant's hips will slide under the lap belt or the occupant's neck will strike the shoulder belt.

Seat Cushion Tilt (1) (if equipped)

To change the angle of the front part of the seat cushion: Press the front part of the control switch up to raise or down to lower the front of the seat cushion. Release the switch as soon as the seat reaches the desired position.

Seat Cushion Height (2) (if equipped)

To adjust the seat cushion height: Press the rear part of the control. Move the switch up to raise or down to lower the seat cushion height. Release the switch as soon as the seat reaches the desired position.

Lumbar Support (Driver's Seat, if equipped)

The lumbar support can be adjusted by pressing the lumbar support switch. Press the front part of the switch (1) to increase support or the rear part of the switch (2) to decrease support.