Hyundai Genesis DH Quiz
Body Electrical System

Blind-Spot Detection Switch Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
7steps
~42min
2/5difficulty
Done 0 of 7

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the lower driver airbag panel. (Refer to Body - "Driver Airbag Module")
  3. Remove the blind-spot detection (BSD) switch (A) after releasing the mounting clip.

Installation

  1. Install the side airbag switch assembly after connecting the connector.
  2. Install the emergency pad lower panel.

Inspection

  1. Disconnect the BSD switch connector.
  2. Turn on the BSD switch, then check the circuit continuity between the terminals of the BSD switch connector.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.