ECS-G Sensor Repair Procedures

Replacement

1. 1
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the front wheel and tire (A) from the front hub.

   Tightening torque: 88.3 ~ 108 N·m

   

   Be careful not to damage the hub bolts when removing the front wheel and tire.

3. 3
   Remove the wheel guard.
4. 4
   Loosen the bolt and remove the G-sensor.

   Tightening torque: 3.9 ~ 5.9 N·m

   [Front RH]

   

   [Front LH]

   

   Remove the rear upper front arm, then the rear upper rear arm.

5. 5
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
6. 6
   Remove the rear wheel and tire (A) from the rear hub.

   Tightening torque: 88.3 ~ 108 N·m

   

   Be careful not to damage the hub bolts when removing the rear wheel and tire.

7. 7
   Remove the luggage compartment side trim [RH]. (Refer to Body - "Luggage Compartment Trim")
8. 8
   Loosen the bolt and remove the G-sensor.

   Tightening torque: 3.9 ~ 5.9 N·m

   

Installation

1. 1
   Installation is in the reverse order of removal.
2. 2
   Perform ESC variant coding. (Refer to ECS (Electronic Control Suspension) System - "ECS Control Unit")