Hyundai Genesis DH Quiz
Restraints

Front Impact Sensor (FIS) Repair Procedures

In this manual: Restraints
General Information — 9Engine Mechanical System — 103Engine Electrical System — 54Emission Control System — 23Engine Control System/Fuel System — 127Automatic Transmission System (SBC) — 90All-Wheel Drive (AWD) System — 20Drive Shaft and Axle — 27Suspension System — 41Steering — 19Restraints — 56Brake System — 56Body (Interior and Exterior) — 211Body Electrical System — 279Heating, Ventilation, and Air Conditioning — 55
9steps
~54min
3/5difficulty
01020304050107N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Removal

  1. Disconnect the negative battery cable and wait at least three minutes before starting work.
  2. Remove the radiator assembly. (Refer to Engine Mechanical System - "Radiator")
  3. Disconnect the front impact sensor connector (A) and loosen the nuts to remove the front impact sensor (B). [Front Impact Sensor]

Installation

  1. Install a new front impact sensor.
  2. Tighten the front impact sensor mounting nut.

    Tightening torque: 8.0 ~ 10 N·m

  3. Connect the front impact sensor connector.
  4. Install the radiator assembly.
  5. Connect the negative battery cable.
  6. After installing the front impact sensor, check that the system operates correctly: Turn the ignition switch ON; the SRS indicator should illuminate for approximately six seconds and then go off.

Test yourself

A quick Hyundai Genesis DH quiz: every answer comes with an explanation and a link to the manual page.