Side Impact Sensor (SIS) Repair Procedures

Removal

1. 1
   Disconnect the negative battery cable and wait at least three minutes before starting work.
2. 2
   Remove the front door trim panel. (Refer to Body - "Front Door Trim")
3. 3
   Disconnect the front side impact sensor connector (A), then remove the front side impact sensor mounting screws to remove the sensor (B).

   

4. 4
   Disconnect the negative battery cable and wait at least three minutes before starting work.
5. 5
   Remove the rear wheel well cover. (Refer to Body - "Rear Wheel Well Cover")
6. 6
   Disconnect the rear side impact sensor connector (A), then loosen the rear side impact sensor mounting bolt to remove the rear side impact sensor (B).

   

Installation

1. 1
   Install a new front side impact sensor with the screws, then connect the front side impact sensor connector.

   Tightening torque: 3.0 ~ 4 N·m

2. 2
   Install the front door trim panel. (Refer to Body - "Front Door Trim Panel")
3. 3
   Connect the negative battery cable.
4. 4
   After installing the front side impact sensor, check that the system operates correctly: Turn the ignition switch ON; the SRS indicator should illuminate for approximately six seconds and then go off.
5. 5
   Install a new rear side impact sensor with the bolt, then connect the rear side impact sensor connector.

   Tightening torque: 8.0 ~ 10 N·m

6. 6
   Install the rear wheel well cover. (Refer to Body - "Rear Wheel Well Cover")
7. 7
   Connect the negative battery cable.
8. 8
   After installing the rear side impact sensor, check that the system operates correctly: Turn the ignition switch ON; the SRS indicator should illuminate for approximately six seconds and then go off.