Front Seat Cushion Cover Repair Procedures

Replacement

Wear gloves to avoid cutting your hands.

When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components. When removing interior trim components, use a plastic panel removal tool to avoid damaging the surface. Be careful not to bend or scratch the trim and panels.

1. 1
   Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly")
2. 2
   Remove the front seat rear shield outer cover. (Refer to Front Seat - Front Seat Shield Outer Cover)
3. 3
   Remove the front seat inner shield cover. (Refer to Front Seat - Front Seat Inner Shield Cover)
4. 4
   Remove the front seat side section protective garnish (A) and the cushion.

   

   

5. 5
   Remove the front seat cushion ventilation duct (A).

   

6. 6
   Remove the protector (A) and separate the front seat cushion cover from the front seat cushion frame (B).

   

7. 7
   Remove the front seat cushion cover (A) from the front seat cushion frame.

   

8. 8
   After removing the hook-and-loop fastener (A) and ring clips (B) inside the front cushion trim, remove the seat back trim (C).

   Make sure the wire insert of the pad is not displaced.

   

9. 9
   Install in the reverse order of removal.

   Make sure the connectors are fully connected. To prevent wrinkles, make sure the cover (B) is stretched evenly before connecting the clips (A). Replace the ring clips with new ones using the special service tool (C) (09880-4F000).

   ? How to Remove and Install the Front Seat Cushion Cover Clip Remove the clip by inserting the tip of a flat-tip screwdriver into the slot. Install the clip by inserting the tip of a flat-tip screwdriver into the slot.