TPMS Receiver Repair Procedures

Replacement

1. 1
   Disconnect the negative (-) battery cable.
2. 2
   Remove the airbag. (Refer to Body - Airbag)
3. 3
   Disconnect the connector.
4. 4
   Remove the bracket (B) and receiver (C) by loosening the nut (A).

   Tightening torque: 3.9 ~ 5.9 N·m

   

5. 5
   Install in the reverse order of removal.
6. 6
   Reconnect the battery, then turn the ignition on.

   Firmly secure the receiver connector until it clicks.

7. 7
   Replace the receiver, then perform the registration procedure using the scan tool (GDS).

Diagnostic Procedure Using the Scan Tool

The following section describes how to diagnose malfunctions using the scan tool.

1. 1
   Connect the scan tool to the diagnostic link connector (16-pin) under the protective cover on the driver's seat side, then turn the ignition on to activate the scan tool.
2. 2
   In the GDS vehicle type selection menu, select "Vehicle Type" and "TPMS System", then select "OK".

   

   

   

   

   

   

   

   

[Tire Pressure Monitor Sensor ID Registration (Wireless)] [Entering Vehicle Name] [Entering VIN]