Hyundai i20 Quiz
MANUAL TRANSMISSION SYSTEM

Control Cable Repair Procedures

In this manual: MANUAL TRANSMISSION SYSTEM
General Information — 17Engine Mechanical System — 79Engine Electrical System — 50Emission Control System — 22Engine/Fuel Control System — 107Clutch System — 27MANUAL TRANSMISSION SYSTEM — 21Drive Shaft and Axle — 18Suspension System — 29Steering System — 21Restraint — 41Braking System — 53Body Work (Interior and Exterior) — 190Body Electrical System — 181Heating, Ventilation and Air Conditioning — 58
27steps
~162min
5/5difficulty
0102030405013.710N·mlb·ft
Tightening torque found on this page
Done 0 of 27

Inspection

  1. Check that the shift select cable operates correctly and is not damaged.
  2. Check that the shift cable operates correctly and is not damaged.
  3. Check that the bellows are not damaged.
  4. Check that the bellows seals are not damaged, scratched, blocked, restricted or torn.

DEPOSIT

  1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")
  2. Disconnect the battery and battery tray. (Refer to Engine Electrical System - "Battery".)
  3. Remove the ECM. (Refer to Engine Control System - "ECM".)
  4. Disconnect the shift select cable (A) and shift cable (B) after removing the snap ring (C).
  5. Remove the shift lever knob and boot (A).
  6. Remove the floor console assembly. (Refer to Body group - "Console")
  7. Remove the air duct (A).
  8. Remove the snap ring (A) and disconnect the shift select cable (B) from the shift lever.
  9. Remove the snap ring (A), then disconnect the shift cable (B) from the shift lever.
  10. Remove the retainer (A) after loosening the nuts (B, 2 EA).
  11. Remove the shift select cable and shift cable from the vehicle.

REMEDY

  1. Install the retainer (A) and nuts (B).

    Tightening torque: 8.8 - 13.7 N·m

  2. Install the shift cable (B), then secure the pin (A).
  3. Install the shift select cable (B), then install the snap ring (A).
  4. Move the lock device (B) in the "F" direction by pulling the bracket (A) in the "P" direction.
  5. Install the shift select cable (A) and shift cable (B), then secure the stud bolts (C, 2 EA).
  6. Tighten the bracket (A) in the "P" direction after fixing the lever (B) in the "F" direction.
  7. Remove the stop pin (A).
  8. Install the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")
  9. Install the battery and battery tray. (Refer to Engine Electrical System - "Battery".)
  10. Install the air duct (A).
  11. Install the floor console assembly. (Refer to Body group - "Console")
  12. Install the shift lever knob and boot (A).

Test yourself

A quick Hyundai i20 quiz: every answer comes with an explanation and a link to the manual page.