INTERIOR CRUISE CONTROL Repair Procedures

Removal and Installation

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the driver airbag module. (Refer to Restraints - "Driver Airbag Module and Clock Spring (DAB)")
3. 3
   Remove the steering wheel. (Refer to Steering System - "Steering Wheel")
4. 4
   Loosen the screws to remove the steering wheel rear cover. (B)

   

5. 5
   Disconnect all connectors and remove the wiring (A) from the steering wheel.

   

6. 6
   Remove the remote control switch assembly on the steering wheel (A) after loosening the screws.

   

   

7. 7
   Remove the cruise control switch (A) after loosening the screws.

   

REMEDY

1. 1
   Assemble the steering wheel remote control switch after connecting the connector.
2. 2
   Install the driver airbag module.

Inspection

1. 1
   Disconnect the cruise control switch connector from the control switch.

   

2. 2
   Measure the resistance between the terminals on the control switch when each function switch is in the ON position (switch pressed).

   INTERIOR FUNCTION	Thick head	Resistance
   GROUP	5 February	330 Ω ± 5%
   Down (▽)	5 February	550 Ω ± 5%
   Down (▽)	5 February	880 Ω ± 5%
   GOOD	5 February	1.44 kΩ ± 5%

3. 3
   If not within specification, replace the switch.