Side Airbag Module Repair Procedures

DEPOSIT

1. 1
   Disconnect the negative battery cable and wait at least 3 minutes before starting work.
2. 2
   Remove the front seat assembly. (Refer to Body - "Front Seat")
3. 3
   Remove the seat cover. (Refer to Body - Seatback)
4. 4
   Loosen the SAB (A) mounting nuts and remove the module from the SABS.

   

REMEDY

1. 1
   Remove the key from the ignition switch.
2. 2
   Disconnect the negative battery cable and wait at least three minutes.
3. 3
   Install a new seat cover. (Refer to Body - Seatback)
4. 4
   Install the front seat assembly. (Refer to Body - Front Seat.)
5. 5
   Tilt and slide the front seat fully forward again, check that the wiring harness is not pinched, and check that it does not interfere with other components.
6. 6
   Connect the battery negative cable.
7. 7
   After installing the side airbag (SAB), check that the system operates correctly.

   • Turn the ignition switch to ON; the SRS warning lamp should illuminate for approximately six seconds and then go off.