Passenger Airbag Repair Procedures

DEPOSIT

1. 1
   Disconnect the negative battery cable and wait at least three minutes before starting work.
2. 2
   Remove the glove box. (Refer to Body - "Glove Box")
3. 3
   Disconnect the passenger airbag connector (A) and remove the PAB mounting bolts (B).

   

   

4. 4
   Remove the impact pad. (Refer to Body - "Instrument Panel")
5. 5
   Remove the instrument panel mounting bolts. Then remove the front passenger airbag.

   

REMEDY

1. 1
   Remove the key from the ignition switch.
2. 2
   Disconnect the negative battery cable and wait at least three minutes before starting work.
3. 3
   Place the front passenger airbag on the instrument panel, then tighten the airbag mounting bolts.

   Tightening torque: 8.0 ~ 12 N·m

4. 4
   Install the crash pad. (Refer to Body - Instrument Panel)
5. 5
   Place the passenger airbag (PAB) on the protective pad and tighten the passenger airbag (PAB) mounting bolts.

   Tightening torque: 4.0 ~ 6 N·m

6. 6
   Connect the passenger airbag wiring harness connector to the SRS main harness connector.
7. 7
   Install the glove box. (Refer to Body - Glove Box)
8. 8
   Connect the battery negative cable.
9. 9
   After installing the passenger airbag (PAB), check that the system operates correctly:

   • Turn the ignition switch to ON; the SRS warning lamp should illuminate for approximately six seconds and then turn off.