TRANSMITTER Repair Procedures

Inspection

1. 1
   Check that the red indicator light flashes when the lock button on the transmitter is pressed.
2. 2
   If the red indicator does not flash, remove the battery (A) and check its voltage.

   Standard voltage: 3 V

   

3. 3
   Insert the battery (A) into the tester (09954-2P100).

   

4. 4
   Press the check button. If "0.00" is displayed on the screen, the battery voltage is 2 V or less.
5. 5
   If the letter "L" is displayed on the screen, the battery is low and must be replaced.
6. 6
   To avoid electric shock, turn off the tester.
7. 7
   If the voltage is low, replace the transmitter battery with a new one, then try locking and unlocking the doors with the transmitter by pressing the lock and unlock buttons five or six times.
8. 8
   If the doors lock and unlock, the transmitter is working. If the doors do not lock or unlock, record the transmitter code, then try locking and unlocking the doors.
9. 9
   If the doors lock and unlock, the transmitter is working normally. Otherwise, replace the transmitter.

Transmitter Code Registration (with GDS)

1. 1
   Connect the GDS DLC cable to the Data Link Connector (16 pins) in the lower driver's side instrument panel finish panel, then connect GDS.

   

2. 2
   Select the vehicle model, then select "SAVE CODE".

   

3. 3
   After selecting the "SAVE CODE" menu, press the "ENTER" key. The screen will display as shown below.

   

4. 4
   After removing the ignition key from the cylinder, press the "ENTER" key to proceed to the next coding mode. After steps 1 to 4 are completed, coding is finished.