Repair Procedures of ABS Control Module

Removal

1. 1
   Turn the ignition switch OFF, then disconnect the negative (-) battery cable.
2. 2
   Disconnect the intercooler inlet hose (A) from the turbocharger, then remove the intercooler inlet pipe (B). [Gasoline 1.6 T-GDI] Tightening torque: Clamp: 4.9–6.9 N·m Mounting bolt: 18.6–24 N·m

   

3. 3
   Pull up the HECU connector lock, then disconnect the connector (A).

   

4. 4
   Disconnect the brake tubes from the HECU by turning the nuts (6 pcs.) counterclockwise using a wrench.

   Tightening torque: 12.7–16.7 N·m

   

   Tightening torque: 18.6 – 22 N·m

   

5. 5
   Loosen the ABS control module mounting bolt and nut (A) on the vehicle.

   Tightening torque: 12.7–16.7 N·m

   

6. 6
   Separate the bracket (B) after removing the mounting bolt from the HECU (A).

   

Installation

1. 1
   To install, reverse the removal procedure.
2. 2
   After installation, bleed the brake system. (Refer to ABS - "ABS System Bleeding".)