Hyundai Kona Quiz
Body Electrical System

Back-Up Lamp Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
11steps
~66min
3/5difficulty
Done 0 of 11

Removal

Left-Hand Drive
  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear bumper. (Refer to Body - "Rear Bumper")
  3. Loosen the screw and remove the back-up lamp assembly. [Right side only]
  4. Remove the back-up lamp bulb. [Right side only]
  5. Disconnect the negative (-) battery terminal.
  6. Remove the rear bumper. (Refer to Body - "Rear Bumper")
  7. Loosen the screw and remove the back-up lamp assembly. [Left side only]
  8. Remove the back-up lamp bulb. [Left side only]
Right-Hand Drive

Installation

  1. Install the back-up lamp.
  2. Install the rear bumper.
  3. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.