Hyundai Kona Quiz
Body Electrical System

Turn Signal Lamp Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
12steps
~72min
3/5difficulty
Done 0 of 12

Removal

Front turn signal lamp
  1. Disconnect the negative (-) battery terminal.
  2. Remove the daytime running lamp (DRL). (Refer to Lighting System - "Daytime Running Lamp (DRL)").
  3. Remove the bulb socket, then remove the bulb.
  4. Disconnect the negative (-) battery terminal.
  5. Remove the rear bumper. (Refer to Body - "Rear Bumper")
  6. Loosen the screw, then remove the turn signal lamp assembly.
  7. Remove the turn signal lamp bulb.
Rear Turn Signal Lamp

Installation

Front turn signal lamp
  1. Install the turn signal lamp.
  2. Connect the negative (-) battery terminal.
  3. Install the turn signal lamp.
  4. Install the rear bumper.
  5. Connect the negative (-) battery terminal.
Rear Turn Signal Lamp

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.