Hyundai Kona Quiz
Body Electrical System

Hazard Warning Switch Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
6steps
~36min
2/5difficulty
Done 0 of 6

Inspection

  1. Check for continuity between the terminals. If continuity is not as specified, replace the hazard warning switch.

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the right crash pad garnish assembly. (Refer to Body - "Crash Pad Garnish").
  3. Disconnect the connectors (A).

Installation

  1. Install the hazard warning switch.
  2. Install the right crash pad garnish assembly.
  3. Connect the negative (-) battery terminal.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.