Hyundai Kona Quiz
Body Electrical System

Rear Combination Lamp Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
9steps
~54min
2/5difficulty
Done 0 of 9

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the outside rear combination lamp assembly after disconnecting the connector.
  3. Remove the bulb (A) by turning it counterclockwise. [LED Type]
    [Bulb Type]
  4. Remove the inside rear combination lamp cover.
  5. Disconnect the inside rear combination lamp connector (A) after removing the rear combination lamp cover.
  6. Remove the inside rear combination lamp assembly after loosening the nuts.
  7. If it is necessary to replace the bulb, remove the bulb after removing the luggage compartment cover.
    1. Remove the rear combination lamp connector.
    2. Remove the bulb by turning it counterclockwise.

Installation

  1. Install the inside combination lamp assembly after installing the bulb.
  2. Install the rear combination lamp assembly after installing the bulb and connecting the lamp connector.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.