Hyundai Kona Quiz
Body Electrical System

Blind-Spot Collision Warning Indicator Repair Procedures

In this manual: Body Electrical System
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
8steps
~48min
2/5difficulty
Done 0 of 8

Removal

Blind-Spot Collision Warning Indicator
  1. Disconnect the negative (-) battery terminal.
  2. Remove the mirror (A).

Installation

Blind-Spot Collision Warning Indicator
  1. Install the outside mirror.
  2. Connect the negative (-) battery terminal.

Inspection

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door inside quarter trim panel (A).
  3. Disconnect the power outside mirror connector from the wiring harness.
  4. Apply battery voltage to each terminal as shown in the table, and check that the mirror operates correctly.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.