Propeller Shaft Repair Procedures

Removal

1. 1
   After making alignment marks on the flange yoke and transmission companion flange, remove the driveshaft mounting bolts (A).

   Tightening Torque: 49.0–64 N·m

   

2. 2
   Remove the center bearing bracket mounting bolts (A).

   Tightening Torque: 49.0–64 N·m

   

3. 3
   Make alignment marks on the flexible coupling and companion flange and the corresponding marks on the differential carrier, then remove the propeller shaft mounting bolts.

   Tightening Torque: 49.0–64 N·m

   

Inspection

1. 1
   Check the front and rear flexible couplings for cracks or damage.
2. 2
   Inspect the flexible coupling centering sleeve. If the sleeve is damaged, replace the propeller shaft assembly.

   

3. 3
   Install the dial indicator so that its plunger contacts the center of the front propeller shaft or rear propeller shaft.
4. 4
   Slowly rotate the propeller shaft and check the runout. Repeat this procedure for the other propeller shaft.

   Propeller shaft runout: 0.3 mm (0.012 in.)

   

5. 5
   Place the transmission in Neutral or N.
6. 6
   Raise the vehicle and make sure it is securely supported.
7. 7
   Inspect the CV joint boot (A). If the CV joint boot is damaged, replace the propeller shaft assembly.

   

8. 8
   Check the CV joint for excessive movement. If present, replace the propeller shaft.

Installation

1. Install in the reverse order of removal.