Hyundai Kona Quiz
Suspension System (without ECS)

Rear Coil Spring Repair Procedures

In this manual: Suspension System (without ECS)
General Information — 17Engine Mechanical System — 85Engine Electrical System — 50Emission Control System — 26Engine Control System/Fuel System — 152DCT (Dual Clutch Transmission) System — 50Four-Wheel Drive (4WD) System — 21Propeller Shaft and Axle (2WD-FF) — 28Suspension System (without ECS) — 32Steering — 21Restraints — 38Brake System — 64Body (Interior and Exterior) — 205Body Electrical System — 1Heating, Ventilation, and Air Conditioning — 66
6steps
~36min
2/5difficulty
04080120160200127.594N·mlb·ft
Tightening torque found on this page
Done 0 of 6

Removal

  1. Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
  2. Remove the rear wheel and tire (A) from the front hub.

    Tightening torque: 107.9–128 N·m

  3. Remove the parking brake cable fixed clip (A).
  4. Pull the control lever counterclockwise as shown in the illustration below, then disconnect the parking brake cable (A).
  5. Loosen the bolt and nut, then disconnect the rear shock absorber (A) from the torsion beam axle.

    Tightening torque: 98.1 - 118 N·m

  6. Remove the coil spring.

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Hyundai Kona quiz: every answer comes with an explanation and a link to the manual page.