Rear Axle with Torsion Beam Repair Procedures

Removal

1. 1
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the rear wheel and tire (A) from the front hub.

   Tightening torque: 107.9–128 N·m

   

3. 3
   Remove the brake caliper from the torsion beam axle. (Refer to Brake System – Rear Disc Brake)
4. 4
   Remove the rear hub carrier. (Refer to Driveshaft and Axle - "Rear Hub - Carrier")
5. 5
   Loosen the bolt and nut, then disconnect the rear shock absorber (A) from the torsion beam axle.

   Tightening torque: 98.1 - 118 N·m

   

6. 6
   Remove the coil spring.

   

7. 7
   Disconnect the rear wheel speed sensor connector (A).

   

8. 8
   Remove the wheel speed sensor cable bracket (A) and the parking brake cable bracket (B).

   

9. 9
   Remove the torsion beam axle mounting bolts (A) and nuts (B), then remove the torsion beam axle.

   Tightening torque: 98.1 - 118 N·m

   

10. 10
    Remove the torsion beam axle bracket (A).

    Tightening torque: 98.1 - 118 N·m

    

Replacement

1. 1
   Remove the rear axle with torsion beam from the vehicle. (Refer to Rear Axle with Torsion Beam - "Removal")
2. 2
   Using SST (09551-AL100) and a press, replace the bushing (A).

   

Installation

1. Install in the reverse order of removal.