Rear Shock Absorber Repair Procedures

Removal

1. 1
   Loosen the wheel nuts slightly. Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the rear wheel and tire (A) from the front hub.

   Tightening torque: 107.9–128 N·m

   

3. 3
   Remove the rear shock absorber (A) from the body by loosening the bolt.

   Tightening Torque: 49.0–64 N·m

   

4. 4
   Loosen the bolt and nut, and remove the rear shock absorber (A) from the torsion beam axle.

   Tightening torque: 98.1 - 118 N·m

   

Disassembly

1. 1
   Remove the lock nut cover (A).

   

2. 2
   Using the special service tool (09546-3X100), install the self-locking nut.

   

3. 3
   Separate the bracket assembly (A), rubber bumper (B), dust cover (C), and shock absorber (D).

   

Inspection

1. 1
   Inspect the rubber components for wear and deterioration.
2. 2
   Compress and extend the piston rod (A) and check for abnormal resistance or unusual noise during operation.

   

Installation

1. 1
   To reinstall, perform the removal procedure in reverse order.
2. 2
   Using the SST (09546-3X100), install the lock nut.

   Tightening torque: 19.6–24 N·m

   

3. 3
   Install the lock nut cover (A).

   

Installation

1. Install in the reverse order of removal.