Rear Door Glass Repair Procedures

Replacement

1. 1
   Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")
2. 2
   After removing the mounting screws, remove the rear door handle full support bracket (A).

   

3. 3
   Disconnect the rear door speaker connector (A).

   

4. 4
   Remove the rear door trim panel seal (A).

   

5. 5
   Slightly loosen the bolt and nut of the rear door channel (A). Tightening torque: Nut: 7.8–11.8 N·m 5.8–8.7 lb-ft Bolt: 8.8–114 N·m 6.5–10.1 lb-ft

   

6. 6
   Loosen the mounting screws, then remove the rear door outside weatherstrip (A) by pulling it upward.

   

7. 7
   Remove the rear door triangular molding (A) by removing the mounting screws.

   

8. 8
   Remove the rear door belt inside weatherstrip (A).

   

9. 9
   While holding the power window switch, pull it down until the glass mounting bolt is visible through the plug hole.
10. 10
    Loosen the mounting bolt and remove the rear door glass (A) by tilting it to the side.

    Tightening torque: 7.8–11.8 N·m

    

11. 11
    To install, reverse the removal procedure.