Repair Procedures

Adjustment

1. 1
   Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")
2. 2
   After removing the mounting screws, remove the rear door handle full support bracket (A).

   

3. 3
   Disconnect the rear door speaker connector (A).

   

4. 4
   Remove the rear door trim panel seal (A).

   

5. 5
   Loosen the window glass mounting bolts, adjust the glass gap by moving the glass (A) from side to side, then tighten the bolts.

   

6. 6
   Check that the window operates normally.

1. 1
   Loosen the mounting screw, adjust the latch (A) by moving it forward and backward or side to side, then tighten the bolts (B).

   Tightening torque: (B): 21.6–32 N·m

   

2. 2
   Tap the striker with a plastic hammer to adjust it. The striker will not move much, but will allow some adjustment.
3. 3
   While holding the outer handle, press the door against the body to check that the striker plate sits flush with the body. If the door latches correctly, tighten the screws and recheck.

1. 1
   Make sure the door and body edges are parallel.

   

2. 2
   When adjusting the doors, place the vehicle on a hard, level surface.
3. 3
   Adjust the hinges (A):

   • Slightly loosen the door mounting bolts and move the door inward or outward until it is level with the body.
   • Slightly loosen the hinge mounting bolts and move the door rearward or forward, upward or downward as needed to make the gaps even.
   • Place a shop towel on the jack to avoid damaging the door when adjusting the door.

   Tightening torque: (B): 21.6–26 N·m (C): 23.5–31 N·m

   

4. 4
   Apply grease to the hinge moving parts indicated by the arrows.
5. 5
   Check for water leaks.