Back Door Glass

Components and Component Location

Component Location

Repair Procedures

Replacement

1. 1
   Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")
2. 2
   Using a removal tool, separate the rear door belt outer weatherstrip from the seal (A).

   

3. 3
   Remove the rear door belt inside weatherstrip (A).

   

4. 4
   Using a removal tool, remove the rear door triangle molding (A).

   

5. 5
   Slightly loosen the rear door channel mounting bolt and nut. Tightening torque: Nut: 7.8–11.8 N·m Bolt: 7.8–11.8 N·m

   

6. 6
   Remove the plug hole cover (A).

   

7. 7
   While holding the power window switch, pull it down until the glass mounting bolt is visible through the plug hole.

   Be careful not to damage the glass surface.

8. 8
   Loosen the mounting bolt and remove the rear door glass (A) by tilting it to the side.

   Tightening torque: 7.8–11.8 N·m

   

9. 9
   To install, reverse the removal procedure.

   Make sure the glass raises and lowers smoothly. If necessary, adjust the glass position. Make sure the door locks and unlocks properly. Replace any damaged clips (or pin-type retainers).