Rear Wheel Speed Sensor

Components and Component Location

COMPONENTS

[ 2WD ]

(4WD)

Repair Procedures

DEPOSIT

1. 1
   Remove the front wheel and tire assembly (A) from the hub.

   Tightening torque: 88.3 ~ 108 N·m

   

2. 2
   Disconnect the rear wheel speed sensor connector (A). [2WD only]

   

3. 3
   Remove the wheel speed sensor cable bracket (B). [4WD only]

   Tightening torque: 6.9 ~ 10.8 N·m

   

4. 4
   Remove the rear wheel speed sensor mounting bolt (B). [4WD only]

   Tightening torque: 6.9 ~ 10.8 N·m

   

5. 5
   Loosen the nuts securing the trailing arm, then remove the trailing arm (A).

   Tightening torque: 98.1 ~ 118 N·m

   [ 2WD ]

   

   (4WD)

   

6. 6
   Remove the wheel speed sensor cable by loosening the bolt (B).

   Tightening torque: 8.8 - 13.7 N·m

   

7. 7
   Remove the wheel speed sensor cable bracket bolt (B).

   Torque: 19.6 ~ 29 N·m

   

8. 8
   Remove the luggage compartment trim. (Refer to Body - "Luggage Compartment Trim".)
9. 9
   Disconnect the rear wheel speed sensor connector, then remove the front wheel speed sensor.
10. 10
    To install, perform the removal procedure in reverse order.

Inspection

1. 1
   Measure the output voltage between the wheel speed sensor terminal and ground.

   

2. 2
   Compare the change in wheel speed sensor output voltage with the normal output voltage change specified below.

   

   T_low: 0.59 V ~ 0.84 V, V_sup: 1.18 V ~ 1.68 V, Frequency range: 1~2500 Hz