DRAIN OIL

Components and Component Location

COMPONENTS

Repair Procedures

DEPOSIT

1. 1
   Remove the engine undercover. (Refer to Engine and Transaxle Assembly - "Engine Undercover")
2. 2
   Drain the engine oil. (Refer to Lubrication System - "Engine Oil")
3. 3
   Remove the oil pan (A).

   1. Loosen the bolts.
   2. Insert the blade of the special service tool (09215-3C000) between the upper crankcase and the oil pan. Separate the sealant applied and remove the oil pan.

      

4. 4
   Remove the oil filter (A) with gasket (B).

   

REMEDY

1. 1
   Install the oil filter (A) with a new gasket (B). Tightening torque Bolt: 19.6 ~ 26 N·m Nut: 11.8 ~ 13.7 N·m

   

2. 2
   Install the oil pan.

   1. Use a scraper to remove the old sealant from the sealing surfaces.
   2. The sealant contact surfaces on the oil pan and the lower crankcase must be free of foreign matter, harmful substances, oil, dust, and moisture. Spray cleaner onto the surface and wipe with a rag.
   3. After applying liquid sealant to the oil pan, install it within 5 minutes of applying the sealant. Sealant must be applied continuously to prevent oil leakage. Bead width Full section: 4.0 ~ 5.0 mm (0.16 ~ 0.20 in) Section A: 1.5 ~ 2.5 mm (0.06 ~ 0.10 in) Sealant: Threebond 1217H (Hyundai Grey RTV)

      

   4. Install the oil pan (A). Tighten the bolts evenly, several times.

      Tightening torque: 9.8–11.8 N·m

      

3. 3
   Fill the engine with engine oil.