Body Work (Interior and Exterior)
Center Crash Pad Panel
In this manual: Body Work (Interior and Exterior)
14steps
~84min
4/5difficulty
Done 0 of 14
Components and Component Location
COMPONENT LOCATION

| 1. Center panel circuit board |
Repair Procedures
REPLACEMENT
- Remove the floor console assembly. (Refer to Floor Console - Floor Console)
- Remove the crash pad lower panel. (Refer to Instrument Panel - Lower Panel)
- Remove the instrument cluster panel. (Refer to Instrument Panel - Lower Panel)
- Remove the heater and A/C control assembly. (Refer to Heating, Ventilation, Air Conditioning - "Heater and A/C Control Assembly (Manual)") (Refer to Heating, Ventilation, Air Conditioning - "Heater and Air Conditioning Control Assembly (DATC)")
- Remove the two stoppers (B) from the glove box (A) by turning them.

- Separate the air vent (A) from the glove box (B).

- Disconnect the latches (A) and remove the glove box (B).

- Using a screwdriver or a remover, remove the side cover of the crash pad [D] (A).

- Using a screwdriver or a remover, remove the crash pad under cover [D] (A).

- Loosen the mounting screws and remove the ventilation panel with protector pad [D] (A).

- Loosen the mounting screws and bolts, then remove the center safety pad panel (A).

- Disconnect the power/off button connector (A).

- Disconnect the glove box lamp connector (A) and the glove box lamp switch connector (B).


- To install, perform the removal procedure in reverse order.
Test yourself
A quick Hyundai Tucson quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?