Front Seat Cushion Covering

Components and Component Location

COMPONENT LOCATION

Repair Procedures

REPLACEMENT

1. 1
   Remove the front seat assembly. (Refer to Front Seat - Front Seat)
2. 2
   Remove the front seat inner cover. (Refer to Front Seat - "Front Seat Inner Cover")
3. 3
   Remove the front seat outer cover. (Refer to Front Seat - "Front Seat Outer Cover")
4. 4
   Remove the front seat lower shield (A).

   

5. 5
   Disconnect the clip and remove the ventilation hose (A).

   

6. 6
   Disconnect the front seat motor connectors (A).

   

7. 7
   Loosen the mounting screws and remove the airbag wiring (A).

   

8. 8
   Disconnect the power seat limit switch connector (B).

   

9. 9
   Loosen the front seat back frame mounting bolts (B).

   Tightening torque: 44.1 ~ 54 N·m

   (LH)

   

   (RH)

   

10. 10
    Disconnect the front seat back (A) and front seat cushion (B).

    

11. 11
    Disconnect the front seat heater connector (A).

    

12. 12
    Remove the protector (A) from the front seat cushion frame.

    

    (Rear)

    

    [Coast]

    

    

13. 13
    Disconnect the connector (A), then remove the ventilation hose (B) by loosening the screws.

    

14. 14
    Remove the front seat cushion covering (A) from the front seat cushion frame.

    

15. 15
    After removing the hook-and-loop fastener (A) and clips (B) inside the front seat cushion covering, remove the covering from the seat cushion (C).

    

    

    

16. 16
    To install, perform the removal procedure in reverse order.